SIMPLE.BORE

Simple.Bore Kits are designed and fabricated by Zach and his team at R.S.Restorations. Check them out at www.rsrbuilds.com.

This kit is designed to bore out the center of transport wheels to fit your factory hubs. In case you didn’t know, the center of transport wheels are too small to fit directly on a C10. This kit will allow you to fit your transport wheels without using spacers or paying big money for a machine shop to bore them!  

A few things to know: 

- This kit was designed to work the best with an air ride suspension with a raised bed floor. If you bore your wheels on a lowered truck, it may cause rubbing on your inner wheel tubs. 

- If you’re bagging your truck and raising the bed floor, to use factory rear tubs, you will need to have an inch gap in between the bed inner fender and the tub. If you have any questions, contact me. 

- This kit will not work with a stepside bed unless you have cut into your inner bed sides. I recommend using this 1 inch spacer: 

https://amzn.to/3GvaNNO

The SIMPLE.BORE kit will include the following:

- Steel Guide Bracket

- Grade 8 Hardware

- Bi-Metal Hole Saw and Arbor Drill Attachment

- Link to the DIY Installation Video 

- Simple.C10 Sticker!!!

Installation Video:

Parts mentioned in the video:
Simple.Bore Kit: https://simplec10.myshopify.com/products/simple-bore
Simple.Bore (Guide Bracket Only): https://simplec10.myshopify.com/products/simple-bore?variant=40488637825097
Blue Cutting Lubricant: https://amzn.to/40Rly56
1-inch Spacers: https://amzn.to/3GvaNNO

(By purchasing this kit, you’re taking full responsibility of the installation. Simple.c10 is not liable for any damages that occur during or after installation.)